PreviousNext

1955 - 1957 (Later Model Model 55) Complete Chevy Truck A/C System

1955 - 1957(Later Model Model 55) Complete Chevy Truck A/C System

More Views

  • 1955 - 1957(Later Model Model 55) Complete Chevy Truck A/C System
  • 1955 - 1957(Later Model Model 55) Complete Chevy Truck A/C System Control Upgrades
  • 1955 - 1957(Later Model Model 55) Complete Chevy Truck A/C System Upgrade Options

Availability: In stock

Be the first to review this product

Part #CK-5557CHPU
$949.99

1955 - 1957 Chevy truck A/C system, later model 1955 trucks. Heat air and defrost system. This kit will mount on the passenger side of the firewall, it will not interfere with the glove box. The kit requires the removal of the factory heater box from inside the vehicle. The kit has vent pods period correct for the 1955-1957 Tri 5 model Chevy Pickups. Several upgrade options are available.

$949.99

Details

1955 - 1957 Chevy truck A/C system, later model 1955 trucks. Heat air and defrost system. This kit will mount on the passenger side of the firewall, it will not interfere with the glove box. The kit requires the removal of the factory heater box from inside the vehicle. The kit has vent pods period correct for the 1955-1957 Tri 5 model Chevy Pickups. Several upgrade options are available.

The kit is complete and includes the following (Kit contents can vary depending on options picked):

  • Evaporator kit with expansion valve and mounting hardware, grommets. This Evaporator does not have vents for floor heat.
  • Controls, vents, and Under-Dash panel
  • R-134a Hose kit (See hose kits Page for contents)
  • Black O-ring drier with drier straps
  • 14 x 24 Condenser with condenser mount kit
  • Sanden Style A/C compressor with clutch
  • Compressor mount kit (to fit your engine)
  • HI / Lo binary pressure switch
  • Directions

If you need a different size condenser please specify the size in the checkout section. The compressor will come with a double V-belt clutch unless a different setup is requested. Pulleys and a radiator fan are not included. A fan and fan shroud should be used on the radiator, or a sufficient electric fan. The setup requires a double groove water pump pulley, and a triple groove crank pulley. Please specify in checkout if you have a long or short water pump and if the alternator is on the driver or passenger side. A short water pump will sit up against the timing chain cover; a long water pump will have a one inch gap between the rear of the pump and the timing chain cover. The kit does not include the refrigerant, heater hoses, or belt. This kit is available in 12 volt only.

Additional Information

Years Covered 1955-1957
Make Chevrolet
Model Pickup
Instructions 55-57 Chevy Pickup Kit Instructions

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Write Your Own Review

Only registered users can write reviews. Please, log in or register