ID-255 Heat Air In-dash Evaporator Unit
A/C and heat evaporator unit designed to mount behind the dash board. The evaporator has four round duct hose adapters, which use 2.5" flexible duct hose. The controls and the vent louvers can be mounted in the dash or under the dash. We offer a large variety of vents for these units. Please see the duct hose and vents Page for all the different options, if you would like to add defrost see the defrost Y's. The evaporator has a three speed blower motor with a dual fan setup. The evaporator unit has passenger side hose outlets, the fittings for the A/C hoses will be on the passenger side of the unit, the heater hoses will be on the drivers side when it is installed. The unit can be mounted flat or at a 45 degree angle. The unit cannot have the hose adapters pointing straight up. The evaporator has approximately 290CFM and 14000 A/C BTU and 12000 BTU heat . The evaporator unit is compatible with R-134a and R-12 refrigerants.
The evaporator unit includes:
Three speed blower motor
Adjustable temperature thermostat
Evaporator unit mounting hardware
Expansion valve
Drain tube & cork tape for hose fittings
O-rings
Four rubber grommets
Eight feet of 2.5" duct hose
Four vents of your choice.
Knob style controls with a face plate
Heater control valve w/ cable
The evaporator unit measures: 16" wide x 13" deep x 5" tall. This Evaporator does not have vents for floor heat.
If you would like to add this unit to a complete kit please go to the complete kits Page and select the make of your vehicle. In that selection we offer complete kits with "select an evaporator" option. Add this evaporator to your shopping cart, and select the kit for your make, add it to the cart and follow the directions for checkout.
This evaporator unit is manufactured by Nostalgic A/C Parts in the U.S.A.
A/C and heat evaporator unit designed to mount behind the dash board. The evaporator has four round duct hose adapters, which use 2.5" flexible duct hose. The controls and the vent louvers can be mounted in the dash or under the dash. We offer a large variety of vents for these units. Please see the duct hose and vents Page for all the different options, if you would like to add defrost see the defrost Y's. The evaporator has a three speed blower motor with a dual fan setup. The evaporator unit has passenger side hose outlets, the fittings for the A/C hoses will be on the passenger side of the unit, the heater hoses will be on the drivers side when it is installed. The unit can be mounted flat or at a 45 degree angle. The unit cannot have the hose adapters pointing straight up. The evaporator has approximately 290CFM and 14000 A/C BTU and 12000 BTU heat . The evaporator unit is compatible with R-134a and R-12 refrigerants.
The evaporator unit includes:
Three speed blower motor
Adjustable temperature thermostat
Evaporator unit mounting hardware
Expansion valve
Drain tube & cork tape for hose fittings
O-rings
Four rubber grommets
Eight feet of 2.5" duct hose
Four vents of your choice.
Knob style controls with a face plate
Heater control valve w/ cable
The evaporator unit measures: 16" wide x 13" deep x 5" tall. This Evaporator does not have vents for floor heat.
If you would like to add this unit to a complete kit please go to the complete kits Page and select the make of your vehicle. In that selection we offer complete kits with "select an evaporator" option. Add this evaporator to your shopping cart, and select the kit for your make, add it to the cart and follow the directions for checkout.
This evaporator unit is manufactured by Nostalgic A/C Parts in the U.S.A.
