UD-190 1964 - 1967 Ford Mustang Falcon Evaporator Unit

UD-190 1964 - 1967 Ford Mustang Falcon Evaporator Unit

UD-175 Slimline Heat Air Under-Dash Evaporator

UD-175 Slimline Heat Air Under-Dash Evaporator

UD-180 Under-Dash Slimline Air Heat & Defrost Unit

Availability: In stock
Part Number
UD-180
$335.99

A/C, heat and defrost evaporator unit designed to mount under the dash board. The evaporator has four rectangle louvers. A Drivers side option is available for a $15 up-charge by choosing from the options below this description. The controls are located in the center of the unit. The defrost adapter is operated with a cable, and uses 2" duct hose. The evaporator has a three speed blower motor with a dual fan setup. The evaporator unit has passenger side hose outlets, the fittings for the hoses will be on the passenger side of the unit when it is installed. The evaporator has approximately 290 CFM and 14000 BTU A/C & 12000 BTU heat. The evaporator unit is compatible with R-134a and R-12 refrigerants. The evaporator unit measures: 26" wide x 12" deep x 5" tall. This Evaporator does not have vents for floor heat..

A/C, heat and defrost evaporator unit designed to mount under the dash board. The evaporator has four rectangle louvers. A Drivers side option is available for a $15 up-charge by choosing from the options above this description. The controls are located in the center of the unit. The defrost adapter is operated with a cable, and uses 2" duct hose. The evaporator has a three speed blower motor with a dual fan setup. The evaporator unit has passenger side hose outlets, the fittings for the hoses will be on the passenger side of the unit when it is installed. The evaporator has approximately 290 CFM and 14000 BTU A/C & 12000 BTU heat. The evaporator unit is compatible with R-134a and R-12 refrigerants.
The evaporator unit includes:
Three speed blower motor
Adjustable temperature thermostat
Evaporator unit mounting hardware
Expansion valve
Drain tube & cork tape for hose fittings
O-rings
Cable operated heater valve with cable
Four rubber grommets
The evaporator unit measures: 26" wide x 12" deep x 5" tall. This Evaporator does not have vents for floor heat.
If you would like to add this unit to a complete kit please go to the complete kits Page and select the make of your vehicle. In that selection we offer complete kits with "select an evaporator" option. Add this evaporator to your shopping cart, and select the kit for your make, add it to the cart and follow the directions for checkout.
This evaporator unit is manufactured by Nostalgic AC Parts in the U.S.A.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account